MECHANICAL
Standard Crystal Vision module 266mm x 100mm
Weight: 150g
Power consumption: 5 Watts

VIDEO INPUT
One SDI input
SDI 270Mbit to EBU 3267-E and SMPTE 259M
Cable equalisation >200m Belden 8281 or equivalent
Auto or manual 625/525 line selection

VIDEO OUTPUTS
Outputs can be configured as a mixture of composite, Y/C, YUV, RGB and reclocked SDI distribution. The final number of outputs is dependent on the frame rear module fitted:
RM01: 1 SDI, 2 analogue, 2 selectable (SDI or analogue)
RM02: 2 SDI, 4 analogue, 2 selectable (SDI or analogue)
RM18: 2 SDI, 6 analogue, 2 selectable (SDI or analogue)
Board edge push button switch selects composite / Y/C / YUV / RGB. The number of SDI outputs is selected by on board links
ALLDAC is a plug in replacement for both DDAA132 and ENDAC on all rear modules, with signals on the same connector for composite, YUV and RGB. For Y/C outputs it is necessary to select M1 link position for compatibility with DDAA132 and M2 for compatibility with ENDAC
Switchable Betacam levels on YUV output
SDI 270Mbit to EBU 3267-E and SMPTE 259M

ANALOGUE PERFORMANCE
12 bit precision
Frequency response: +/-0.5dB 0 to 5.5 MHz
Differential phase: <1.5 degrees
Differential gain: <1.5%
Signal to Noise: <-60dB

DELAY THROUGH BOARD
3us

GPI OUTPUT LEVELS
Active: connect to ground, 220 ohm current limit resistors. Pulled up to +5V through 10 kohm

GPI OUTPUT
Input absent

LED INDICATION OF:
Power supplies on board
Betacam levels selected
Input standard
Output format

LOCAL CONTROL
Board edge push button switch selects composite / Y/C / YUV / RGB on configurable outputs. On board links configure number of SDI outputs. Separate switch selects Betacam levels (YUV only)

REMOTE CONTROL
RS422/485
19200 baud, 8 bits, 1 stop no parity
Control from frame active front panel and remote panel
Statesman allows control from any PC on a network
SNMP monitoring and control available as a frame option