MECHANICAL
‘Double decker’ module 266mm x 100mm (uses two frame slots)
Weight: 250g
Power consumption: 14 Watts

VIDEO INPUT
Eight 3Gb/s, HD or SD inputs
270Mb/s or 1.5Gb/s or 3Gb/s serial compliant to EBU 3267-E, SMPTE 259M, SMPTE 292M and SMPTE 424M
3Gb/s cable equalisation up to 80m using Belden 1694A. HD cable equalisation up to 140m with Belden 1694A or equivalent (approx. 100m with Belden 8281). SD cable equalisation >250m Belden 8281 or equivalent
Input return loss: -15dB for 50MHz to 1.5GHz and -10dB for 1.5GHz to 3GHz
Auto 50/59.94/60Hz and video format selection

VIDEO OUTPUTS
Three 3Gb/s, HD or SD inputs
270Mb/s or 1.5Gb/s or 3Gb/s serial compliant to EBU 3267-E, SMPTE 259M, SMPTE 292M and SMPTE 424M. Output follows the input format

DELAY THROUGH BOARD
<1us

ROUTING AND TIMING INFORMATION
The eight inputs can be routed to any of the three outputs. One source can go to more than one destination
The SW803 3G allows both immediate routing of a selected single input to a selected output, and multiple routing to change a number of outputs at once by using a macro. Up to 15 macros can be saved and recalled. Macros do not affect all of the outputs and allow part of the routing to be changed
Up to 15 presets (a snapshot of the state of every crosspoint) can be saved and recalled
The switch timing can be either immediate or timed (field or frame)
Vertical interval switching to SMPTE RP168-2009
Timing information is provided by either an HD tri-level syncs or SD Black and Burst analogue reference, or by a digital reference generated from any of the four main board inputs. The serial video formats supported are 625, 525, 720p50, 720p59.94, 720p60, 1080i50, 1080i59.94, 1080i60, 1080p50, 1080p59.94  and 1080p60

LED INDICATION OF:
Power supplies
Eight inputs present

GPI INPUT LEVELS
Active pull to ground, pulled up to +5V through 4700 ohm

GPI OUTPUT LEVELS
Electrically: Open collector transistors 30V, 270 ohm current limit resistors. Pulled up to +5V through 6800 ohm

GPI INPUTS
Five GPI inputs – configurable for input selection/routing

GPI OUTPUTS
One GPI output – user configurable

LOCAL CONTROL
Intuitive board edge interface with two select buttons, shaft encoder and ten character alphanumeric display

REMOTE CONTROL AND MONITORING
RS422/485
19200 baud, 8 bits, 1 stop no parity
Control from frame active front panel and remote panel
SW808 Controller is a dedicated 1U control panel allowing tactile operation
Statesman allows control from any PC on a network
SNMP monitoring and control available as a frame option