MECHANICAL
Standard Crystal Vision module 266mm x 100mm
Weight: 140g
Power consumption: 1.4 Watts

ANALOGUE VIDEO INPUTS
One SD or HD analogue input
SD or HD composite video input, 1 volt with syncs. Composite PAL or NTSC. Component video up to 30MHz bandwidth
SD Black and Burst, HD Tri-level syncs, or 2 volt syncs
Loop-through available with RM16 frame rear module, or 75 ohm termination. Loop-through does not need VDA to be fitted - rear connector has all circuitry required
Differential input with RM02 and RM16 rear modules

ANALOGUE VIDEO OUTPUTS
Maximum of eleven outputs using the RM18 rear module (five outputs with RM01, eight with RM02 and ten with RM16)

PERFORMANCE
Input Return Loss: >48dB to 10MHz
Output Return Loss: >48dB to 10MHz
Frequency Response: +/-0.05dB 0 to 6MHz, +/-0.2dB 6 to 10MHz, +/-1.5dB 10 to 30MHz
Differential Gain: <0.2% at 5MHz
Differential Phase: <0.4 degrees at 5MHz
Signal to Noise Ratio at 0 to 10MHz: <70dB
Cable equalisation: Belden 8281 manual adjustment up to 300m
Gain adjustment: +/-3dB manual adjustment

DELAY THROUGH BOARD
20ns

LED INDICATION OF:
SD or HD present indication
Power supplies okay

GPI OUTPUT LEVELS
Electrically: Open collector transistors 30V, 270 ohm current limit resistors. Pulled up to +5V through 6800 ohm

GPI OUTPUTS
One GPI output: Input detect

LOCAL CONTROL
Board edge control of cable equalisation 0-300m and gain +/-3dB
Video monitoring test point BNC allows waveform monitor to be plugged straight into the board